Publicidad
Idiomas disponibles
Idiomas disponibles
3.4.
Cleaning and maintenance
Set the mill on"coarse". Without any grain in the hopper, turn it on. Hold a vacuum cleaner tube against
the flour outlet and then against the grinding outlet.
If the millstones are smeared with an oily residue, you can clean them by grinding a cup of wheat or rice at
the medium setting. This should remove all traces of the residue.
You can also remove the upper millstone to clean the millstones with a brush.
However, it is very important whenever you handle the millstones or the milling chamber, that you first
unplug the power cord!
Afterwards, remove the hopper by unscrewing it (counterclockwise). You can remove the upper millstone
to clean the millstones with a brush.
a)
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
•
Wait for the rotating elements to stop.
b)
Use only non-corrosive cleaners to clean the surface.
c)
Use only mild, food-safe detergents to wash the device.
d)
After cleaning the device, all parts should be dried completely before using it again.
e)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
f)
Do not spray the device with a water jet or submerge it in water.
g)
Do not allow water to get inside the device through vents in the housing of the device.
h)
Clean the vents with a brush and compressed air.
i)
The device must be regularly inspected to check its technical efficiency and spot any damage.
j)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
k)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN
Grind Setting:
1 – Fine
2 - Coarse
Publicidad
