Royal Catering RCGM-01 Manual De Instrucciones página 18

TROUBLESHOOTING:
Problem
The motor hums, but the grain is
not taken up.
The motor binds during operating.
EN
Simply turn the hopper and set the mill on "COARSE" until the motor
starts. Then readjust the mill to the desired texture.
If the motor binds during the operating, this may be caused by
overheating due to your improper use. To protect the motor from
serious damage, a built-in thermal cut-off switch is designed. Unplug
and allow the mill to cool down. Try to restart the mill, if this problem
reoccurs, you need to troubleshoot the source:
• Is the grain too moist?
• Are the millstones or the mill chamber clogged?
Is there a foreign object caught between the millstones?
•
• Did you turn on the mill with the hopper full and the
millstones at the finest grind setting?
Solution