Publicidad
Idiomas disponibles
Idiomas disponibles
AFTER INSTALLATION
TRANSMITTER IS NOT WORKING
1. Ensure the transmitter is within the 20 foot range of the fan.
2. Check batteries to insure they are good and oriented correctly. The indicator should light up when
the button is pressed.
NOISY
When it is quiet(especially at night) you may hear occasional small noises. This is normal. Please
allow a 24-hour "breaking-in" period, most noises associated with a new fan disappear during the
time.
WOBBLE
The fan blades have been adjusted in the factory to minimize any wobble.
NOTE:CEILING FANS TEND TO MOVE DURING OPERATION DUE TO THE FACT THAT THEY
ARE MOUNTED ON A RUBBER CROMMET. IF THE FAN WAS MOUNTED RIGIDLY TO THE
CEILING, IT WOULD CAUSE EXCESS VIBRATION. MOVEMENT OF A FEW CENTIMENTERS IS
QUITE ACCEPTABLE AND DOES NOT SUGGEST ANY PROBLEM.
TO REDUCE THE FAN WOBBLE: PLEASE CHECK THAT ALL SCREWS WHICH SECURED
THE MOUNTING BRACKET AND DOWNROD ARE SECURE.
CARE AND CLEANING
1.To ensure a proper and safety usage, inspect the suspension system and tighten all connections
every 6 months.
2.Periodic cleaning of your ceiling fan. Use a soft brush or lint free cloth to avoid scratching the
paint finish. Please make sure to turn off electricity power before you clean your fan.
3.Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and
create the possibility of an electrical shock.
4.The bulbs and near by parts will be still hot after the power is shut off. To avoid burn, please
clean them after they are cooled down.
5.Motor has permanently lubricated ball bearing. No need to oil.
NOTE: MAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX BEFORE YOU
ATTEMPT ANY CLEANING OR REPAIRS.
Installation & Operating Instructions for the
Parrotuncle Owner's Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
F 4615-SMART
Publicidad
