Descargar Imprimir esta página

MSW Motor Technics MSW-GTC-100L Manual De Instrucciones página 41

Armario para herramientas

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 123
The installation of the garage cabinet set is finished.
Drawer Removal
Put the drawer out so that it's almost fully extended. Push up on the black release lever on one side, while
pulling down on the black release lever on the other side. While holding the levers in the positions as
illustrated below, pull the drawer outward until it is released from the drawer slide.
3.2.
Cleaning and maintenance
a)
Use only non-corrosive cleaners to clean the surface.
b)
After cleaning the device, all parts should be dried completely before using it again.
c)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
d)
Do not spray the device with a water jet or submerge it in water.
e)
The device must be regularly inspected to check its technical efficiency and spot any damage.
f)
Use a soft, damp cloth for cleaning.
g)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
h)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
i)
Lubricate the slides twice a year with a quality lubricant. This is especially necessary when the
temperature drops, which may cause the bearings to be stiff.
EN
Push up one side
Push down the other
side

Publicidad

loading

Este manual también es adecuado para:

Msw-gtc-200g