EN
Safety
Technical data
Supply
220-240 VAC, 50/60 Hz
voltage:
LED 30 W
The light source of this luminaire
is not replaceable; when the light
Bulb type:
source reaches its end of life the
whole luminaire shall be replaced.
Do not stare at the operating light
source.
Weight: 0.61 kg
Product:
Dimension:
H. 18 x W. 17.6 x D. 13.9 cm
Max. projected area: 18.1 m
This product complies with
conformity requirements of the
applicable European Regulations
or Directives.
Troubleshooting
Symptom
Light does not switch on
when there is movement in
the coverage area.
216383_s1_s45-5059340191423_5059340230801-Blooma-A5-IM-V03-Multi.indb 3
216383_s1_s45-5059340191423_5059340230801-Blooma-A5-IM-V03-Multi.indb 3
2
Possible Cause
The power switch is turned off
The light fixture is not properly
attached to the mounting plate, if
this is a new installation (the pins
are not fully seated in the terminal
block)
The circuit wiring is incorrect
(if this is a new installation)
The sensor is aimed in the wrong
direction. Detection zone not
properly targeted
Another light source is causing the
unit
Energy
This product contains a light
efficiency
source of energy efficiency class
class:
<F>.
Class I product, must be
connected to earth.
Minimum distance from lighted
objects (0.5 metres).
IP65
Jet-proof
Waste electrical products should
not be disposed of with household
waste. Please recycle where
facilities exist. Check with your
Local Authority or local store for
recycling advice.
Do not use with a dimmer switch.
xxWyy
xx-year; yy-week of the year
Solution
Check that the power is switched
ON at the circuit breaker/internal
wall switch
Re-install the light fixture to the
base and ensure the pins are fully
seated in the terminal block
Check the wiring connections,
ensure no connections are loose
Re-aim the sensor to cover the
desired area
Turn off surrounding lights and/or
re-aim the sensor head
03
30-09-2021 15:10:49
30-09-2021 15:10:49