Troy-Bilt 020210 Manual Del Propietário página 9

Operation
HOWTO USE PRESSURE
If you have any probHems operating your pressure washer,
pHeasecaHH the pressure washer heHpHine at 1-888-61 1-6708.
How to Start Engine
The best way to start your pressure washer for the first
time is to follow these instructions step-by-step.Ths
starting information aHsoappHies if you have Hetthe unit sit
idHefor at Heasta day.
H. PHacepressure washer near an outside water source
capabHe of suppHying water at a flow rate greater than
5.0 gaHHons per minute and no Hessthan 20 PSI at
pressure washer end of garden hose.
2. Hake sure unit is in a HeveH position.
3. Check that high pressure hose is connected to spray
gun and pump. See "Preparing Pressure _A/asher for
Use" for iHHustrations.
4.
Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Squeeze trigger on gun untiH you have a steady stream
of water.This purges pump of air and impurities.
6. Attach nozzHe extension to spray gun (Figure 7).
Tighten by hand.
7. Choose spray tip you want to use and insert it into
nozzHe extension. See "How to Use SprayTips'.
8. AppHy safety Hatch to spray gun trigger (Figure 8).
Safety Latch
Start engine according to instructions given in engine
owner's manuaH.AHso see operating instructions tag
Hocated on the pressure washer.
CAUTION
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback,
• [f engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spr D, gun.
NOTE: AHways keep the throttle
Hever in the "Fast"
position when operating the pressure washer.
How to Stop
Pressure Washer
* Turn engine off according to instructions given in engine
owner's manua[.
* Squeeze
trigger on the spray gun to remieve
pressure in the hose.
NOTE: A smaHHamount of water wiHH squirt out when you
release the pressure.
O