GreenWorks G40HT Manual Del Operario página 135

WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the engine stops before
you install or remove the battery packs.
• Use only 24V battery packs. Do not use dual-voltage
24/48V battery packs.
• Both battery packs should be installed in the
compartments in order to start the machine.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
4. Do the same operation with the other battery pack.
Optimize the power and performance of your new
2x24V machine by running with both battery packs
charged to 100%. If each battery has a different charge
state, the run-time of the machine is subject to the lowest
powered battery (For example: one battery is charged
100%, and the other is charged 50%, the unit will only
run until the 50% battery is depleted).
3.5 REMOVE THE BATTERY PACK
Figure 10.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
4.1 START THE MACHINE
Figure 11.
1. Push the on/off button in the on position.
2. Turn the speed dial forward to increase speed.
4.2 STOP THE MACHINE
Figure 11.
1. Push the On/off button.
4.3 OPERATION TIPS
• Make sure that the machine is in good condition.
• Make sure that the tubes and guards are in position.
• Do not point the machine at the person or loose materials
before you start the unit.
• Ear protection is necessary to decrease the risk of hearing
loss related to noise level.
• Obey all applicable laws, regulations, standards and
ordinances.
NOTE
English
4.4 OPERATE AS A GARDEN VAC
Figure 12.
1. Hold the machine tightly.
2. Hold the machine in a way the suction pipe is slighty
tilted 5 - 10 cm above the floor.
3. Use a sweeping action to collect light unwanted
materials.
Make sure that you install and zip the bag.
Use the shoulder strap.
4.5 OPERATE AS A BLOWER
1. Hold the machine tightly.
2. Operate from side to side.
3. Move the machine forward slowly.
4. Keep the collected unwanted materials in front of you.
Use rakes and brooms to loosen the unwanted material
before you blow.
Use the low speed to move dry items, and high speed to
move heavy items such as large unwanted materials or
gravel.
5 MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Remove the battery pack from the machine before
maintenance.
5.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
5
NOTE
NOTE
NOTE
NOTE
CAUTION
CAUTION
WARNING
CAUTION
EN