Annex Iii: Assembly Manual For Covered Kronos: Models Rk - Carbel KRONOS 100 Manual De Instrucciones

Annex III: assembly manual for covered Kronos: models RK

The Kronos models are available with a covered version, RK-100 and RK-80, these have various options of
finishes: suspended, with foot, or with wood compartment.
Even though various options are described here, not all of them might be suitable for your particular project.
In any case it is preferable that a professional does the installation. If you are planning on doing your own
installation, please consult a professional beforehand.
The installation of the stove should comply with all local norms, including those that refer to national and
European rulings.
All RK models have an optional exterior air inlet for combustion air. This air inlet can be connected either at
the back side or at the bottom of the device. It is important to connect one or other depending on the type
of installation.
When installing the RK models it's essential the security distance for combustable material should be
observed.
Security distancias for combustible material:
RK– 100 and RK-80
In front of the device: 1600 mm
Sides of the device: 500 mm
Back of the device: 200 mm
RK– 70 and RK-60
In front of the device: 1600 mm
Sides of the device: 600 mm
Back of the device: 500 mm
In case of installing a suspended model, please ensure the wall is able to support the weight of the device
and the firewood load. Likewise, a professional in charge of installation should decide on the appropriate
hardware needed to secure the device to the wall.
If during installation the device should be scratched, the distributor has heat resistant spray paint in store.
38