Gadnic CODBAR11 Manual De Usuario página 60

Configure Channel
1. Scan one of below channel
2. Scan will make beep beep beep beep ... sound
3. Plug the USB receiver, the beep sound
immed iately.(Configure sucessfully)
If the beep sound was not stopped after you plug the USB
receiver please repeat step 1,2 and plug the USB receiver on
another USB port.
1 One-to-one wireless data transmission:
、
In the same environment, there are many scanning guns
used at the same time, so d ifferent channels need to be
allocated to d ifferent scanning guns to prevent d ata
crosstalk. This bar cod e need s to be scanned.
2 One-to-many wireless data transmission:
、
On the same computer, multiple scanners are required to
share a receiver, and "one-to-many mode" barcodes need to
be scanned.
One-to-one pairing
One-to-many pairing
60
will stop