Proxxon GG 12 Manual página 8

Loose clothes, jewellery or long hair can be
caught in moving parts.
g) If devices are provided for the connec-
tion of dust extraction and collection
facilities, ensure these are connected
and properly used.
Use of these devices can reduce dust
related hazards.
h) Only allow trained personnel to use the
power tool.
Apprentices may only operate the power
tool when they are aged over 16, when this
is necessary for their training and when
they are supervised by a trained operative.
4.) Power tool use and care
a) Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch
does not turn it on and off correctly.
Any power tool that cannot be controlled
with the switch is dangerous and must be
repaired.
c) Disconnect the plug from the power
source before making any adjustments,
changing accessories, or storing power
tools.
Such preventive safety measures reduce
the risk of starting the power tool acciden-
tally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools carefully. Check
for misalignment or binding of moving
parts, breakage or damage of parts and
any other condition that may affect the
power tools operation. If damaged, have
the power tool repaired by a qualified
expert before use.
Many accidents are caused by poorly main-
tained power tools.
- 8 -
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Secure the workpiece.
Use clamps or a vice to hold the workpiece.
This is safer than holding it with your hand,
and also it frees both hands to operate the
equipment.
5.) Service
a) Have your power tool serviced by a
quali fied repair person using only identi-
cal replacement parts.
This will ensure that the safety of the
power tool is maintained.