JMB 54386 Manual De Instrucciones página 6

Connect the platform to the power supply.
Turn the switch to the ON position.
Press the UP button to raise the platform.
If necessary, adjust the tilt of the platform or
adjust the pads position.
Make sure the battery rests perfectly on the
pads.
Remove the remaining screws that attach the
battery to the vehicle.
Remove any remaining bolts from the vehicle
component and put the load on the platform.
Press the DOWN button until the table is at
lowest position.
Note: While you hold down the DOWN button,
the buzzer will make a sound.
Move the lift out from under the vehicle
Installing the battery
Put the battery on the platform.
Position the lift under the vehicle.
If necessary, adjust the tilt of the platform.
Press the Up button to raise the platform.
Follow the manufacturer's instructions to install
the battery correctly.
Emergency stop
If you need to stop raising or lowering the pla-
tform, press the red button on the remote con-
trol.
Rubber pad adjustment
If you wish, you can vary the position of the
pads.
To do this, loosen the screw at the base of the
pad.
After adjusting the position, tighten the bolt
again.
You can also change where the pads are pla-
ced.
To do this, the platform has multiple holes in
which to place the pads.
Unscrew the bolt completely.
Place the pad in another location.
Screw the bolt back in.
If needed you can adjust the height of the
pads with a wrench,
· 6 ·
REF.54386