Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: Never immerse the device in water or any other liquid.
Installing and changing the battery
• Twist the battery compartment cover counterclockwise to open. Insert
one AA battery [NOT INCLUDED] inside the battery compartment
aligning the positive and negative ends correctly.
• Replace the cover and turn it clockwise until it clicks into place.
• Batteries should only be inserted or changed by an adult.
• Do not use rechargeable batteries.
• Non-rechargeable batteries should never be recharged.
• Be sure to insert batteries in accordance with indicated polarities.
• Do not store batteries near flammable materials.
• Store batteries in a cool, dry place at normal room temperature.
• Remove batteries from the device in case of extended storage.
• Do not short-circuit the supply terminals.
• Recycle used batteries responsibly. Do not throw into the household
waste bin.
• Do not leave batteries in the device that is not to be used for a long time.
How to use
Note: prior to first use, test the trimmer on a small area on your arm or leg. In case
you experience any allergic reaction or oversensitivity, d iscontinue use immed iately.
Do not use on sensitive and irritated skin.
How to trim your beard
1. Gently twist beard trimming head counterclockwise and remove. The
trimming head fits both towards the front and back of the trimmer.
Align the head so it easily slots into place, then turn clockwise to lock.
2. Slide the ON/OFF switch in the direction of the trimming head.
3. Position beard trimming head at a slight angle to your skin so
that cutting blades glide lightly over the surface of your skin.
4. If trimming head becomes filled with hair, turn the d evice off and
use the supplied brush to remove all hair, then continue trimming.
5. After each use, remove the trimming head and rinse und er warm
running water. Dry the head with a soft cloth and replace.
How to trim nose and ear hair
1. Gently twist beard trimming head counterclockwise and remove.
Align the head so it easily slots into place, then turn clockwise to
lock.
2. Slide the ON/OFF switch in the direction of the trimming head.
3. Carefully guid e the trimmer along the outer cavity of your nose/
ear. Do not insert the trimmer any deeper than 3mm into your nose
or ear.
4. If trimming head becomes filled with hair, turn the d evice off and
use the supplied brush to remove the build-up, then continue
trimming as desired.
5. After each use, remove the trimming head and rinse under warm
running water. Dry the head with a soft cloth and replace.
8
Rev.1
Publicidad
