Publicidad
Idiomas disponibles
Idiomas disponibles
Before First Use
IMPORTANT: Please check all packaging material carefully before discarding as there may be
accessory parts contained within the packaging material.
Note: Please clean the appliance before first use to remove any dust or particles remaining
from manufacturer. We recommend running the cycle once without adding any tea, or
coffee.
1.
Place your appliance on a clean, dry, and heat resistant level counter.
2.
Remove the Tumbler, Lift lid to remove Reusable Filter and Basket.
3.
Wash all with warm soapy water. Rinse and dry thoroughly.
4.
Fill the Tumbler to the 'Water Mark', do not over fill.
5.
Pour in the water and add the basket and reusable filter to the machine.
6.
Do not add any ingredients to the Reusable Filter and close the Lid.
7.
Run a brew cycle with water only.
8.
When the brewing cycle is complete, turn your iced tea /coffee maker off. Discard the water
that has boiled in the Tumbler and once it has cooled (5 minutes) rinse the Tumbler, Lid, and
Reusable Filter basket.
9.
Your machine is now ready to brew your first drink.
Using Your Iced Tea Maker:
WARNING: Avoid contact with hot parts.
This machine can be used with ground coffee, Tea Bags, and loose tea leave.
TIP: We strongly suggest using distilled water when you brew, this will help the performance
of your machine. Please read cleaning and maintenance for further instructions.
Attention:
First use may cause a slight odor or small smoking upon heating, it is normal. This
is a result of the heating element chemical reaction. It quickly goes away.
1.
Lift Lid and remove Reusable Filter and Basket.
2.
Fill the ''Tumbler' with cold, fresh water to the "Water" line. Then pour the water into
the water reservoir. Do not fill past the "Max" line.
3.
Add desired Coffee or Tea to the Reusable Filter and place Basket and Reusable Filter
with ingredients into the machine and close the Lid.
Note: Use 4 to 6 tablespoons of ground coffee (depending on desired preference).
4.
Fill the Tumbler with Ice Cubes to the Ice Mark line.
5.
Place the Tumber with ice under the Drip Spout.
6.
Select your strength by using the Brew Strength Selector.
7.
Plug the power cord into the nearest Power supply (outlet).
8.
Press the "Power Button". The light on the Power Button will illuminate, letting you
know the power is on.
9.
Once the brew cycle has finished, (3-4 Minutes) turn the appliance off by pressing the
Power Button.
Note: This appliance does not have an automat shut off feature.
10. When the brew cycle is complete, remove the Tumbler from under the Drip Spout.
5
Publicidad
