Gloria FineCut 230V Instrucciones De Uso página 28

branches and bushes will result in a
loss of pre-tension and thus reduce
the quality of the grass cut.

Check the lawn surface to be trimmed
beforehand to avoid damage to
appliance and objects or injuries to
living beings. Power lines, stones,
pieces of wood, wires or the like, as
well as other foreign objects must be
removed. Objects that the grass shear
pick up can be cut.
NOTE!
6
Slide the loop of the extension cable
into the designated cable strain relief (C)
in the handle (A) and fix it in the desig-
nated clip.
7
Use an extension cable to connect the
device to a power outlet (230 V AC).
8
Remove the blade guard (I).
9
Clean the grass shear before or after each
use. Oil the blades with machine oil or
spray lubricating oil before or after use.

Before using the grass shear, first mow
the lawn using the lawnmower / lawn
robot.

Adjust the cutting height (3/4/5 cm) as
described in section 6.2.

Place the
switch the appliance on. To switch ON,
firstly press and hold the lock-off button
(B). Then press the ON/OFF safety switch
(D) and keep it pressed.
10
Now move the appliance once slowly
forwards and back on the lawn. Do not
apply pressure to the appliance. Leav-
ing the grass shear at one position for
too long can damage the turf.
NOTE!
If too much cut grass settles on the
blade bar, switch off the appliance, lift it
slightly and shake off the grass.
ATTENTION
Improper use of the appliance poses a
risk of damage to property! You
should therefore observe the follow-
ing safety instructions:

When cutting around curbs, fences, or
trees, make sure the blade bar does
not come into contact with them.
9
Oil the blades at least once an hour
(machine oil or spray lubricating oil).
on the lawn and
28
7.1.1 Angle adjustment
Your is equipped with an
angle adjustment mechanism (G) which
allows you to trim your lawn even in hard-
to-reach areas. Proceed as follows to
adjust the angle of the tube:
CAUTION
RISK OF INJURY FROM OSCILLATING
METAL BLADES!

Switch off your appliance when
adjusting the angle!
Figures 11 - 12
11
12
- Press both angle adjustment but-
tons (G) simultaneously to adjust
the tube. The angle (G) can be
adjusted in 9 stages. You can
therefore work under obstacles
when it is set flat.
8 Maintenance & Cleaning
Figures 13 - 23
WARNING
RISK OF INJURY DUE TO UNIN-
TENTIONAL SWITCHING ON AND
SHARP/POINTED BLADES!
Some parts of the grass shear have
sharp edges and could cause injury.
 Switch off the appliance and remove
the mains plug.

Wear protective gloves during main-
tenance and cleaning!

Slide the blade guard (I) onto the
blades (H).
CAUTION
RISK OF BURNS CAUSED BY HOT
PARTS!
During assembly or conversion work the
drive parts of the appliance or compo-
nents can still be very hot and may cause
burns. It is therefore important to