Gloria FineCut 230V Instrucciones De Uso página 29

observe the following safety instruction:

Wear protective gloves during main-
tenance and cleaning!
8.1 Replacing the blades
WARNING
RISK OF CUTTING INJURY FROM
SHARP/POINTED METAL BLADES!

Only assemble with the blade guard
attached (I)!
NOTE!
Tools required:
Phillips screwdriver
13
Loosen and remove the 7 marked base
cover screws on the underside of the appli-
ance.
14
Lift the base cover from the appliance
and remove it.
15
To remove the blade set, loosen and
remove the remaining screw indicated.
16
Lift the blade set from the appliance
and remove it.
17
If necessary, use a brush to clear away any
dirt from the housing and the two seals.
18
Before fitting the new blade set, make sure
that the marks on the two large cog wheels
line up with the marks on the housing. The
two cams must be positioned as shown.
19
Before inserting the new blade set, check
the correct position of the upper blades.
The upper blades need to be positioned
centrally and pointing straight forward as
shown. You may need to align the cams of
the upper blades as shown in the figure.
( = correct /
20
Now attach the new blade set. The central
large stud and the 3 indicated shafts of
the cog wheels, which need to sit in the
openings of the blade set, can be used as
a positioning aid.
21
Fix the blade set by screwing it at the
position indicated.
22
Replace the base cover on the appli-
ance as shown.
23
Then use the 7 screws indicated to
screw the base cover in place.
 Lubricate the new blade with machine oil
or lubricating oil spray before using.
The blade set has now been replaced.
= incorrect).
29
8.2 Cleaning
ATTENTION
Improper use of the appliance poses a risk of
damage to property! You should therefore
observe the following safety instruction:

Switch off the appliance and remove
the mains plug.

Do not immerse the appliance in
water or spray or clean it with water.
The appliance must be protected
against moisture.

Clean the outside of the appliance with
a damp cloth or soft brush. Do not use
abrasives or harsh cleaning agents.

Dismantle the grass shear for a thor-
ough clean if it is seriously dirty. Use
a brush to clean the cutting unit, the
housing and the two seals, then oil
the blades (J).

Only use original GLORIA spare parts
for repairs.

Further accessories can be found at
https://shop.gloria-garten.com/de/.
9 Decommissioning & Storage
9.1 Decommissioning

Take the appliance out of operation by
releasing the On/Off switch (D) in the
handle.

Switch off the appliance and remove
the mains plug.
9.2 Storage
Figures 24 - 27
CAUTION
You may be exposed to hazards that could
injure you when handling the appliance.
You must therefore store the appliance
away from children.

Remove any dirt and debris.
24
Pull the mains plug out of the socket, then
disconnect the connection coupling.
25
Remove the cable from the strain relief (C).
26
Slide the blade guard (I) onto the
blades (H).
27
Store the appliance hung up, dry and
protected from frost.