Powerplus POWX0910 Traduccion Del Manual De Instrucciones Originale página 36


The direction of feeding the bit into the material is very important and it relates to the
direction of bit rotation. When viewing the tool form the top, the bit rotates clockwise. Feed
direction of cutting must be counter-clockwise (Fig 12). NOTE: inside and outside cuts will
require different feed direction; refer to section on feeding the router. Feeding the tool in
the wrong direction causes the cutting edge of the bit to climb out of the work and pull the
tool in the direction of this feed.

Never use dull or damaged bits. Sharp bits must be handled with care. Damaged bits can
snap during use. Dull bits require more force to push the tool, possibly causing the bit to
break.

Never touch the bit during or immediately after the use. After use the bit is too hot to be
touched by bare hands.

Never lay the tool down until the motor has come to a complete standstill. The spinning bit
can grab the surface and pull the tool out of your control.

Never use bits that have a cutting diameter greater than the opening in the base.
WARNING: Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities contains chemicals known to cause
cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
 Lead form lead-based paints,
 Crystalline silica form bricks and cement and other masonry products, and
 Arsenic and chromium form chemically treated lumber.
Your risk form these exposures vary, depending on how often you do this type of work. To
reduce you exposure to these chemicals: work in a well ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter out
microscopic particles.
7 ASSEMBLY
7.1 Inserting and removing a cutter (Fig. 1)
7.1.1 Inserting a cutter

Press and hold down the spindle lock button (5).

Using the wrench to loosen the collet nut (6) a few turns, insert a collet and a cutter into
order.

Tighten the collet nut and release the spindle lock button.
7.1.2 Removing a cutter

Press and hold down the spindle lock button (5) and loosen the collet nut (6) completely.

Remove the cutter.

Fit a new suitable accessory and tighten the collet nut.
Note: Never tighten the collet nut without a cutter in the collet.
Copyright © 2021 VARO
POWX0910
P a g e | 6
EN
www.varo.com