Publicidad
Idiomas disponibles
Idiomas disponibles
Repeat the procedure at the other side.
CAUTION: Dust may cause respiratory problems. Certain laminated board
materials are carcinogenic. After work, always remove all dust from the
machine.
7.7
Using the dust exhaust connection
The dust exhaustion outlet (14) shall be connecting together with an external vacuum
cleaner to take away the dust in dust cover.
If necessary, place an adapter on the dust exhaust.
8 OPERATION
8.1
Cutting in several operations (Fig. 7)
The length-stop turret (9) can be used to set different depths.
For cutting in depth and in stages, use the length-stop turret (9) as an aid. Using the depth
stop set the desired depth to the lowest depth-stop position on the turret. Rotate the turret so
that the highest point is under the depth stop and execute the first cut. Repeat the cut with the
second-highest setting and finally with the last setting. You can also use two positions if the
desired depth is reached in two operations.
8.2
Switching on and off (Fig. 8-9)
Connect the plug to the power supply.
To switching the tool on, keep the lock-off button (12) depressed and press the ON/OFF
switch trigger (11).
To switching the tool off, release the ON/OFF switch trigger (11).
To adjust the cutting speed, turn the speed control dial (2). Position "1" denotes the lowest
speed. Position "7" denotes the highest speed. Turn the knob to increase or decrease the
speed. The smaller the cutter head, the higher the speed. The larger the cutter head, the
lower the speed. A cutter head which runs too fast causes scorching of the work-piece and
leaves burnt marks.
CAUTION: Do not change the speed when the machine is working under
load.
8.3
Cutting direction
Always observe the safety instructions and applicable regulations.
Always move your router as indicated in below Fig. 10 (outer edges/inner edges).
To prevent the cutter head from jumping and to obtain a good result, carry out exterior
cuts in anticlockwise and interior cuts in clockwise direction.
NOTE: Check that the cutter is correctly installed in the collet.
Place the machine on the workpiece before switching on.
Select the optimal speed using the speed control dial.
Set the cutting depth.
For greater cutting depths it is recommended to make shallow cuts.
Connect a dust cover.
Make sure the locking lever is always locked before switching on.
Copyright © 2021 VARO
POWX0910
P a g e
| 8
EN
www.varo.com
Publicidad
