Jimmy PW11 Manual De Instrucciones página 13

machine and then assemble them back into machine (the
brushroll can be placed in the brushroll housing for drying).
Wash clean the cleaning brush and then put it back into
brushroll housing. (Fig 18)
Note: Do not wash the floorhead with water!
Dust cup cleaning
Press the dust cup release button to remove the dust cup
from the handheld vacuum cleaner. Lift the metal handle on
cyclone to pull out cyclone assembly and empty dust cup.
Hold metal handle and rotate to remove HEPA. (Fig 19)
Maintenance and Storage
1. it is recommended to clean the dirty water tank, dust cup, brushroll after each use. If there is any of below
situation:
1) HEPA filter leaks dust.
2) Foam filter severely damaged.
3) The brushroll has serious hair loss,or has strong vibration and abnormal noise during use.
2. It is recommended to purchase consumables and replace it to avoid machine performance.
3. when the machine is long idled, place it in a cool and dry place, avoid direct sunlight or wet environment.
When pack and store the machine, please be sure to clean the machine and dry all parts to prevent damage
to the machine.
Troubleshooting
Please check the following points before contacting the after sale service.
Problem
Can not start or stop
during use
Weak suction
Abnormal noise
Possible cause
Low battery power
On/off button is not pressed down
Brushroll is entangled
Dirty water tank full
Battery pack not assembled properly
Air path blocked
Suction inlet blocked
No HEPA assembled
Suction inlet blocked
No HEPA assembled
Dust cup release button
19
Solution
Recharge battery
Press down on/off button
Clean brushroll
Clean dirty water tank
Reassemble battery pack
Clean air path and filter
Clean suction inlet and filter
Assemble HEPA
Clean suction inlet
Assemble HEPA
11