Publicidad
Idiomas disponibles
Idiomas disponibles
5. INSTALLATION
CAREFUL!
This unit is designed to be installed and used on a wall.
Keep this information in mind when mounting the unit.
5.1 Package Contents
After unpacking, check that the delivery is complete and that all parts are free of possible
See the image
transport damage.
1. - hood
2. - reducer 150 - 120 mm
3. - non-return valve
5.2 Unit dimensions (mm)
See the pictures
2a
5.3 Safety distances
Observe the safety distances from the unit (calculated in mm).
5.4 Installation steps (Upper Part Exhaust/ Rear Side Exhaust)
Note! Do not connect the power cable until the installation is complete!
1.Drill 3 holes (Φ8mm to accommodate your wall mounts) to install the bracket. Screw and fix
the bracket to the wall using 3 screws (ST4x30mm) and 3 wall plugs (not included). See the
image
4a
2. Place the hood and hang it using the two mounting lugs on the wall bracket.
See the image
4b
3. Slide the top of the pipe mask to the bottom. Install the pipe mask bracket to the
bottom/outer side of it. See the image
4. Attach the duct mask to the hood body and mark the wall mounting holes.
Remove the tubing mask and drill the holes at the marked points.
5. To install the air exhaust system attach the exhaust pipe to the air outlet on the body of
the hood. See the image
6. Reattach the ducting mask to the hood body, passing the air exhaust tube through the
mask and connecting it to the exhaust port, if necessary.
Fix the bracket at the bottom of the ductwork to the wall using 2 dowels and screws (4 x
30mm). See the image
7. Pull up the top/inner part of the pipe mask to the desired height, mark the mounting holes
for the top pipe mask bracket on the wall and pre-drill the marked points.
Fix the top pipe mask bracket to the wall with 2 dowels and 2 ST4 x 30mm screws at the
drilled points.
Fix the top/inner part of the ductwork to the bracket using 2 ST4 x 8mm screws.
See the image
4f
Make sure the bottom of the outer ductwork is resting on the body of the hood. It is not
necessary to screw the ductwork mask to the hood body.
NOTE: to fit the cooker hood with exhaust through the rear of the hood, follow the steps
above, but check the images
5.5 Installation of the air adapter (reduction).
1.
Fix the reduction with the diameter of 150 mm on the connection of the hood.
See the image
5
2. Fix the 120 mm diameter exhaust pipe on the reducer. See the image
3. Seal the joints.
1
2b
2c
2d
4c
4d
4e
4i
4g
4h
EN
for the correct dimensions for the installation.
22
See the image
3
5
Publicidad
