TFA 60.2536 Instrucciones De Uso página 12

TFA_No. 60.2536_Anleit_01_24
Radio-controlled alarm clock
• During night-time, the atmospheric interference is usually less severe and
reception is possible in most cases. A single daily reception is adequate to
keep the accuracy deviation under 1 second.
7. Operation
• Press and hold the – or + button in the respective setting mode for quick set-
tings.
• The device will automatically quit the setting mode if no button is pressed for
15 seconds.
7.1 Manual setting of the clock and calendar
• Press and hold the TIME SET button for three seconds.
• 0 will be flashing.
• Press the – or + button to make the time zone correction.
• Press the TIME SET button to make the settings in the following sequence:
Hours, minutes, seconds, year, month, day, temperature unit (default: °C) and
day-of-week language (default: GER). Press – or + to adjust the settings.
• The manually set time is overwritten once the DCF time signal is successfully
received.
7.1.1 Time zone setting
• In the setting mode you can make the time zone correction (-12/+12).
• The time zone correction is needed for countries where the DCF signal can be
received but the time zone is different from the DCF time (e.g. +1=one hour
plus).
22
22.01.2024 9:57 Uhr Seite 12
Radio-controlled alarm clock
7.1.2 Temperature unit setting
• In the setting mode you can change between °C (Celsius) or °F (Fahrenheit) as
temperature unit.
7.1.3 Setting of the day-of-week language
• In the setting mode you can set the day-of-the week language: German (GER),
English (EN), Dutch (NET), French (FRE), Italian (ITA), Spanish (SPA), Danish
(DAN) and Russian (RUS).
7.2 12-12-HR or 24-HR system
• Press the + button in normal mode to choose 12 HR or 24 HR system. In the
12 HR system AM (before 12 o'clock) or PM (after 12 o'clock) appears on the
display.
7.3 Setting of the alarm times
• Press the ALARM SET button in normal mode, to enter the alarm mode.
• 7:00 (default) or the last adjusted alarm time flashes in the ALARM-1 display.
• Press the – or + button to set the desired alarm time.
• Confirm the setting with the ALARM SET button.
• Alarm times 2, 3 and 4 can be adjusted in the same way.
7.3.1 Activate and deactivate the alarm times
• Move the ALARM 1-4 switch upwards (ON) to activate the alarm function.
• When the alarm time is activated,
alarm display 1-4.
appears in the corresponding
23