Publicidad
Idiomas disponibles
Idiomas disponibles
Depth of drive adjustment
Turn the depth of drive
adjustment knob up or down to
change the driving depth.
Drive a test nail after
each adjustment until the
desired depth is set.
LED worklight
The LED worklights will
be activated when pressing the
workpiece contact.
The LED Worklights
provide feedback to indicate
whether the tool is functioning
properly.(See troubleshooting)
Removing a jammed nail
Try to operate the tool for two
jammed.
Before removing
a jammed nail, open the
remove all the nails.
remove the battery pack
• Keep the magazine open.
12
• Pull up on the tool free jam
release and unhook the latch
• Make sure the tip of the driving
mechanism is in the initial
screwdriver into the tip of the
driving mechanism and push
back.
• Remove any bent nails
• Close the jam release and latch
• Reinstall brad nails and
reactivate the tool
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
20V Cordless 18 Gauge Brad Nailer
See Fig. F
See Fig. G
Always
See Fig. H1,
H2, H3
EN
Publicidad
