Pool Technologie UNO Instrucciones De Uso página 22

6.2. Connecting the reactor to the pipework
1) Use sandpaper to rub down all the surfaces
to be glued: pipework 1, reducers
collars 4.
5
2) Slide each nut 2
(pay attention to the direction).
3) Glue each assembly [pipework
4) Wait for the glue to dry completely.
5) Grease each joint 5.
6) Place each seal 5
7) Screw up and tighten the 2 nuts
6.
8) Screw in the drain plug 7.
6.3. Installing the electrode in the reactor
1) Slide the watertight seal
electrode 2.
5
2) Insert the electrode
on the reactor 4
the electrode to orient this in the reactor).
Screw up and tighten the nut
3)
around the electrode.
3
onto each pipe 1
1 - reducer
inside each collar 4.
2 by hand on the reactor
3 up to the base of the
2 into the location provided for it
(Do not force it: there is a notch on
1 by hand on the reactor,
(if necessary),
3 - collar 4].
1
1
2 3 4 5
2
3
4 5
1
2
3
6
7
4
8