Publicidad
Idiomas disponibles
Idiomas disponibles
6.4. Installing the lamp in the reactor
1) Connect the UV lamp
notch on the cap shows the direction in which to
connect the lamp).
5
2) Insert the UV lamp
provided for it on the reactor
is a notch on the cap so the quartz sleeve can be easily
inserted).
Screw up and tighten the nut
3)
around the cap.
6.5. Installing the flow sensor
1) Remove the plug
Insert the flow sensor
2)
this on the reactor
Caution: comply with the direction of the arrow on the
flow sensor that shows the direction in which the
water flows.
3
to the cap
2
(Do not force it: a
3
delicately into the location
4
(Do not force it: there
1
by hand on the reactor,
2
and its seal
3
1
into the location provided for
4
by tightening the nut by hand.
1
2
3
4
1
2
3
4
9
Publicidad
