Publicidad
Machine Set-up Guide
EN
Fitting the Floor Tool
The floor tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off feature if the
floor tool gets snagged, whilst in transit.
Note: It is easier to fit the floor tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
Fit the floor tool and retain using the
detent pins.
Push waste collection pipe onto the floor
tool; ensure a tight fit.
Note: DO NOT push the vacuum hose
onto the floor tool with the floor tool in
the raised position.
Raise the floor tool for transit or
lower for cleaning operation using
the lifting handle fitted to the back
of the machine.
For fitting the floor tool blades
(See Page 58-63).
Fitting the Hose Guide
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is switched
off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume operation.
Refit vacuum hose to the
Floor tool when finished.
Note: DO NOT push the vacuum hose
onto the floor tool with the floor tool in
the raised position.
28
Publicidad
