Publicidad
Idiomas disponibles
Idiomas disponibles
on automatically when the time
is up.
To cancel the timer function, press
the TIMER button
Automatic switch-off
(sleep timer)
Push the TIMER button
when the product is on.
Use the TEMP– button
TEMP+ button
timer (1–24 hours). The set time
flashes on the display
Push the TIMER button
again to confirm the set time. If
the time is not confirmed and no
further entry is made, the timer
will be cancelled after about
10 seconds. The timer will start
counting down the remaining time
and the product will turn off au-
tomatically when the time is up.
To cancel the timer function, press
the TIMER button
Adjusting the air flow
You can adjust the air flow man-
ually by moving the ventilation
slots
on the front air outlet
2
up or down.
68 GB/MT
The integrated water tank
fills with water in the follow-
once.
ing situations:
21
– At low room temperature and high
21
/
25
– If the product is in dehumidification
to set the
26
.
19
21
Proceed as follows to drain
the water tank:
once.
21
3
Draining the water tank
humidity, the product may not be
able to evaporate the moisture
quickly enough. If this is the case,
water collects in the water tank.
mode, it draws moisture from the
air in the room. Consequently,
water accumulates in the water
tank. When the water tank is full,
the water tank indicator (W.F)
lights up and the error code "E2"
is shown on the display
product stops operating.
Switch off the product and
remove the mains plug
the socket.
Pull the hose connector
back air outlet
the hot air outlet hose
the product.
To empty the water tank, use a
floor cloth or flat bowl that can
absorb/accommodate 0.5 L of
water.
16
. The
19
from
10
off the
15
and remove
7
from
13
Publicidad
