Descargar Imprimir esta página

Ninebot eKickScooter E2 Pro Manual Del Propietário página 6

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
EN
Recommended Maintenance Schedule
7
To ensure safe riding, day to day care and regular maintenance are essential. You, the owner, have control and knowledge of how often
you use your scooter, how hard you use it and where you use it. It is the owner's responsibility to perform regular checks and bring your
scooter to authorized service center for inspection and service. Please refer to the maintenance schedule below.
Note: This maintenance schedule charges a service fee.
Item
Component
Maintenance Method
Mainframe parts
Use a soft, wet cloth to wipe the mainframe clean.
In ate the tires to 50–55 psi.
Tire pressure
Tighten the six screws xed with the handlebar and the
stem. The suggested torque is 5.5±0.3 N·m.
Tighten the screw on the throttle. The suggested torque is
Mainframe
Screws on the
2.5±0.1 N·m.
maintenance
stem top
Tighten the screws on the brake levers. The suggested
torque is 5±0.1 N·m.
Tighten the screws on the stem top. The suggested torque
is 1.7±0.1 N·m.
To accelerate and decelerate, check if the hub motor is
Hub motor
stalled or has abnormal sounds.
Rear wheel
Check if the rear wheel is stalled or gets shaky, or the axis shaft
is unbalanced.
maintenance
Function
1) Spin the rear wheel, it spins normally. The rear wheel shall
Inspection
not stuck or make abnormal sounds.
Note: Slight noise does not affect riding safety. But if the
Drum Brake
drum brake makes loud noises when you apply brakes,
please contact customer service for support.
2) Squeeze the brake lever, the rear wheel stops moving.
09
Every 6
After 2 years or
months or
the total mileage
Every 3
every 310
> 3107 miles
months
miles (500
(5000 km)
km)
Item
Component
Maintenance Method
Ambient light
Check the ambient light and see if it lights normally.
Headlight
Check the headlight and see if it lights brightly.
Toggle the direction indicator switch to the left/right respectively,
Direction
check if the direction indicators on the left/right side ash normally.
Indicators
Dashboard
Power on the scooter, the dashboard works properly.
Press and hold the throttle, then release it, checking for acceleration
Throttle
and deceleration.
After connecting with the Segway-Ninebot app:
Function
1) Update the rmware to the latest version.
Inspection
Fault
2) Check if the noti cation of the corresponding error code and possible
detection
causes will prompt when the scooter detects an error.
Charge the scooter:
1) Check if the current battery power displays on the dashboard.
Charging
2) Check the LED indicator on the battery charger.
Charging: red, Fully charged: green.
Buttons
Press or toggle the button 3 times without failure.
Test with left turns and right turns (the steering angle is 60°).
Steering
No resistance or lag when turning.
The battery need to be replaced when it is charged and
discharged for 500 times or the total mileage is more than 9320
Battery
miles (15000 km).
assembly
Important
Note: It is recommended to charge once every 60 days for
parts
long-term storage.
Controller
It is required that original Segway-Ninebot parts shall be used for
repairs and replacements.
Hub motor
EN
Every 6
After 2 years or
months or
the total mileage
Every 3
every 310
> 3107 miles
months
miles (500
(5000 km)
km)
10

Publicidad

loading

Este manual también es adecuado para:

E2 pro eE2 pro d051405e051405d