Publicidad
Idiomas disponibles
Idiomas disponibles
• The appliance must not be used if it has been dropped,
if it has any visible damage, if it leaks, or if it functions
abnormally in any way. Do not attempt to dismantle your
appliance: have it examined at an Approved Service Centre to
avoid any danger.
• The iron should only be used with the base provided (for
cordless irons).
• Check the electrical power for sign of wear or damage prior
to use. If the electrical power cord is damaged, it must
be replaced at an Approved Service Centre to avoid any
danger.
• Do not use other descaling products than the one cited in
the IFU.
• To achieve optimal results in sanitizing, gently steam back
and forth 3 times on the fabric
Before first use
• When you first use the appliance, some smoke or a harmless odour may be produced or there may be a small discharge of
particles. This will not affect the use of the appliance and will disappear quickly.
What water to use?
• Your appliance has been designed to use tap water.
If your water is very hard (hardness above 30°F, or 17°dH or 21°e), mix 50% tap water and 50% bottled demineralised
water. Never use water containing additives (starch, perfume, aromatic substances, softeners, etc.), or condensation water (for
example water from tumble dryers, water from refrigerators, water from air conditioning units, rainwater). Do not use pure
distilled nor pure demineralised water. Such water contains organic waste materials or minerals that concentrate under the
effect of heat and cause spitting, brown colouring or premature ageing of your appliance.
SAVE THESE INSTRUCTIONS
Environment protection first !
i
Your appliance contains valuable materials which can be recovered or recycled.
Leave it at a local civic waste collection point.
6
Problems with your iron?
PROBLEM
POSSIBLE CAUSES
There is no steam.
The appliance is not plugged in, or
not switched on.
The water level is too low.
The steam pump has not been
primed.
You are using the appliance for the
first time.
The water tank is not fully in place.
The appliance does
It is not plugged in, or not swit-
not heat.
ched on.
Water leaks.
The water tank is not fully in place or
the stopper is not closed properly.
Steam rate decreases.
Scale has built up in the appliance.
You are using water with additives.
The steam leaves stains
on the fabric or the
appliance spits.
The appliance has not been rinsed
enough after the descaling
operation.
You are using other liquids than
white vinegar to descale the
product.
Micro-fiber brush*
You scrub too tightly the textile.
support is removed
from the steam head.
Micro-fiber* is removed
from the micro-fiber
brush* support.
* Depending on model
SOLUTIONS
Check that your appliance is correctly
plugged in and switched on.
Unplug your appliance and refill it.
Press the steam trigger continuously
until the steam appears.
Press the steam trigger continuously
until the steam appears.
Ensure that inlet stopper is closed
and that the water tank clicks/locks
when put into place.
Plug in your appliance and switch on.
Ensure that inlet stopper is closed
and that the water tank clicks/locks
when put into place.
Refer to 'ANTI CALC section in
instructions for use.
Never add any additive in the water
tank.
Refer to ''WHAT WATER TO USE''
section.
Read carefully the 'ANTI CALC'
section in instructions for use.
Use only white vinegar during 'ANTI
CALC' procedure.
Refer to the ''ANTI CALC'' section in
the instructions for use.
Scrub softly the textile to remove
inpregnated dust.
7
Publicidad
