Focal AP 4.380 Manual De Uso página 11

AP 4.380
U s e r m a n u a l
Please validate your Focal-JMlab warranty,
it is now possible to register your product online: www.focal.com/warranty
Thank you for purchasing a Focal product. Welcome to our High-Fidelity world. Innovation, tradition, excellence and
pleasure are our values; our one and only aim is to bring you a sound that is rich, pure and true. To get the most out of your
product, we recommend that you read the instructions in this booklet, then store it in a safe place to refer to in the future.
Package contents
• 1 x AP 4.380 Amplifier
• 1 x Quick Start
• 1 x Set of accessories
Important recommendations
First of all, check that there is enough space to install the amplifier.
• Keep the amplifier clear of any metal shavings and dust particles.
• Clean thoroughly before fitting the amplifier.
Carefully read the section below on installing the amplifier. Plan the layout of the system and wiring. During this preparatory
stage, make sure that all settings will remain accessible once installation is complete.
Before starting the installation, please follow the rules below carefully:
1. After reading the user manual in full, make sure you have understood all the instructions before installing the amplifier.
2. Disconnect the negative lead from the battery before starting the installation (fig. 1).
3. Use good quality connectors/links to connect the amplifier to increase the system's reliability and minimise signal or power
losses.
4. Before performing any procedure, be careful not to cut or puncture the fuel tank, fuel pipe, brake-, hydraulic or vacuum
lines, electrical wiring or any other of the vehicle's safety-related parts.
5. Never run wires underneath the vehicle, they must be installed inside it. When routing the cabling, check that it will not get
in the way when driving the vehicle. Cables that obstruct or protrude in places such as areas around the steering wheel and
pedals (brake, accelerator, clutch, etc.), can be extremely dangerous.
6. Avoid running wires over or across sharp edges. Any wire routed through metal must be protected by cable grommets.
Ensure that cabling is routed away from moving parts (seat rails, etc.) and sharp or pointed edges. This will prevent the cabling
from getting caught or damaged and causing an electrical short circuit.
7. Always protect the battery and electrical circuit from potential damage by using fuses.
Pre-installation wiring
You will only be able to begin fitting the AP 4.380 amplifier once you have connected it using the dedicated spaces on the
product (fig. 2 and 3).
Installation
Position the amplifier in the desired location. Be sure to use suitable screws when drilling holes to fix it to the vehicle floor so
as not to damage the amplifier, vehicle trim or other components (fig. 4).
Our policy of continual product improvement means that Focal-JMlab reserves the right to modify the technical specifications
of its products without notice. Product may vary from images.
11 11