Descargar Imprimir esta página

ST HT 20 Li B Manual De Instrucciones página 138

Cortasetos portátil con alimentación por batería

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 143
Adjustment of the distance between blades is
not necessary, as this is predetermined by the
manufacturer.
7.6.2 Sharpening
It is necessary to sharpen the blades when
the trimming performance decreases and the
branches tend to stick together.
For safety reasons, sharpening must
be done by an Authorised Service Centre
with suitable skills and equipment for the
job; without risking any damage to the blade
which would make it unsafe when used.
Always replace and never repair a blade
which has blunt cutting edges.
7.6.3 Replacement
The blade must never be repaired,
but must be replaced as soon as signs of
breaking, wearing, bending are noted or
the sharpening limit is exceeded. For safety
reasons replacements must be performed by
an Authorised Service Centre.
IMPORTANT Blades
indicated on the Technical Data table should be
used on this machine .
Given product evolution, the blades listed in the
"Technical Data" table may be replaced in time
with others having similar interchangeable and
operating safety features.
8. STORAGE
IMPORTANT The safety regulations to follow
for putting into storage are described in paragraph
2.3. Strictly comply with these instructions to avoid
serious risks or hazards.
8.1 STORING
When the machine is to be stored away:
1. Remove the batteries from their housing;
2. When the cutting means has halted, fit the
blade guard;
3. Allow the engine to cool before storing in an
enclosed space;
4. Clean (para. 7.3);
5. Make sure there are no loose or damaged
components. If necessary, replace any
displaying
the
code
damaged components and tighten any screws
and loose bolts or contact the authorised
service centre;
6. Store the machine:
– in a dry place;
– protected from inclement weather;
– in a place out of children's reach;
– making sure that keys or tools used for
maintenance are removed.
7. the machine can be hung on the wall (Fig. 14.
I - II) .
Make sure that the wall can hold loads of
NOTE
minimum 20 kg
8.2 STORING THE BATTERY
Charge. (par. 7.2.2)
The battery must be stored in closed and humidity-
free environments, at a temperature between:
0°C - 60°C for 1 month
0°C - 45°C for 3 months
0°C- 25°C for 1 year
NOTE If unused for any length of time, charge
the battery every two months to prolong its
working life.
9. HANDLING AND TRANSPORT
Whenever the machine is to be handled or
transported you must:
– Stop the machine (para. 6.5);
– Make sure that all moving parts have come
to a complete stop
– Remove the batteries from their housing
– Wear protective work gloves
– When the cutting means has halted, fit the
blade guard
– Only hold the machine using the hand
grips and position the cutting means in
the opposite direction to that used during
operations
– Make sure that machine movements do not
cause damage or injuries.
When transporting the machine on a vehicle,
always:
– Position it so that it does not cause a hazard
to anyone
– Fasten the machine securely with cables or
chains.
EN - 11

Publicidad

loading