Environmental Conditions; Hydraulic Diagram; Electrical Fuses - Advance RS 501 Instrucciones De Uso

ENVIRONMENTAL CONDITIONS

In the environment where the machine operates, there must not
be any danger of explosion.
To avoid inhaling exhaust gas, the machine must be used only
where there is a proper ventilation.
The machine operates properly (*) in the following
environmental conditions:
– Temperature: -10 °C to +40 °C
– Humidity: 30% to 95%
(*) When using the sweeper at a temperature between -10
°C and 0 °C the dust control system cannot be used;
moreover the water tanks and the dust control system itself
must be empty.

HYDRAULIC DIAGRAM

(See Fig. AS)
50. Hydraulic system oil tank
51. Drain fi lter
52. Suction fi lter
53. Suction fi lter
54. Drive system pump
55. Diesel engine
56. Left drive system motor
57. Right drive system motor
58. Distributor
59. Skirt cylinder
60. Hopper lifting cylinder
61. Hand pump
62. Right broom motor
63. Left broom motor
64. Hydraulic system oil cooler
65. Parachute valve
66. Suction inlet and broom lifting cylinder
67. Check valve
68. Power steering
69. Flow separator (priority valve)
70. Accessory and steering system pump
71. Suction fan pump
72. Distributor
73. Solenoid valve
74. Suction fan motor
75. Power steering cylinder
76. Drive pedal assist
77. Oil fi lter
78. Drive system pump oil fi lter
79. High-pressure washing system pump (*)
80. Flow regulator (*)
81. Breather/fi ller plug
82. High pressure pump safety solenoid valve (*)
(*) Optional
INSTRUCTIONS FOR USE

ELECTRICAL FUSES

At the left side of the control panel there are two fuse boxes
(24 and 25, Fig. D), with a transparent cover, containing the
following fuses:
Fuse box F2 (24, Fig. D)
a) F2.1: Turn signal fuse (10 A)
b) F2.2: Brake light, brake pedal microswitch, reverse gear
buzzer and horn fuse (10 A)
c) F2.3: Running light fuse (10 A)
d) F2.4: Running light fuse (10 A)
e) F2.5: Low beam fuse (15 A)
f) F2.6: High beam fuse (15 A)
g) F2.7: Ignition key lock, main relay, combination switch and
+30 audio unit fuse (10 A)
h) F2.8: Accessory socket power supply fuse (15 A)
Fuse box F3 (25, Fig. D)
i) F3.1: Oil cooler electric fan and solenoid valve control fuse
(20 A)
j) F3.2: Fuel solenoid valve, engine off relay and +15
alternator fuse (15 A)
k) F3.3: Flashing light, climate control system switch and cab
fan switch fuse (15 A)
l) F3.4: Water pump, windscreen wiper, windscreen washer
system pump, climate control system compressor and high
pressure pump safety solenoid valve fuse (20 A)
m) F3.5: Warning light panel power supply, safety electronic
board, drive sensor, ceiling light and +15 audio unit fuse
(15 A)
n) F3.6: +15 turn signal fuse (15 A)
o) F3.7: Climate control system compressor fuse (15 A)
p) F3.8: Door actuator, neutral solenoid valve (optional) and
switch back-light fuse (15 A)
Moreover, the machine electrical power is protected by four
MAXI fuses (36, Fig. E) placed in the relevant fuse box, which
distribute the electrical power to the electrical accessories.
The fuse functions are shown below.
A manual battery release device (100 A), connected on battery
negative terminal and frame, does not allow for machine start-
up if it is not activated.
An emergency push-button on the left side of the dashboard
disables all the accessories except the hazard warning lights.
Fuse box F1 (36, Fig. E)
q) F1.1: Glow plug fuse (40 A)
r) F1.2: Line fuse (60 A)
s) F1.3: Start-up fuse (40 A)
t) F1.4: Alternator fuse (60 A)
Camera kit display power supply (35, Fig. F)
Camera fuse (2 A)
RS 501 33019745(2)2009-12
ENGLISH
15