Publicidad
Idiomas disponibles
Idiomas disponibles
WARNINGS
Before installing the appliance,
make sure that none of the parts
is damaged in any way. In case
of damaged parts, contact your
retailer and do not proceed with
installation.
Read all of the following instruc-
tions with care before installing
the appliance.
- Use an air outlet pipe of the
shortest possible length.
- Limit the number of pipe bends.
- Use a material approved by
standards and regulations.
- Avoid any sudden changes in
pipe section (recommended con-
stant diameter: 150 mm or equal
surface area).
* The appliance is not intended
for use by young children or
infirm persons without super-
vision. Young children should
be supervised to ensure they
do not play with the appliance.
* The cooker surface and the
inferior part of the cooker hood
must be at a minimun distance
of 65 cm.
* The air sucked can't be con-
veyed through or into a duct
used to let out fumes from ap-
pliances fed by energy other
than electric power (eg. centra-
lized heating, radiators, water-
heaters, etc.).
* To evacuate the air outlet,
please comply with the pertai
ning rules given by competent
authorities.
* Provide the room with an ade-
quate aeration when a cooker
hood and appliances fed by
energy other than electric power
(gas-, oil-, or coal- stoves, etc.)
are used simultaneously. The
cooker hood, when evacuating
the sucked air, could generate a
negative pressure in the room-
which can't exceed the limit of
0.04 mbar, in order to avoid the
suck of exhausts deriving from
the heat-source. Therefore the
room should be provided with air-
intakes to allow a costant flow of
fresh air.
If the rating lable in the cooker-
hood shows the symbol
appliance is built in class II°
and it does not need any earth
connection.
If the rating lable in the coo-
ker-hood does not show the
symbol
, the appliance is bu-
ilt in class I° and it needs the
earth connection.
* When performing the electrical
connections on the appliance, plea-
se make sure that the current-tap is
provided with earth connection and
that voltage values correspond to
those indicated on the label placed
inside the appliance itself.
* Before carrying out any clea-
ning or maintaining operations,
the appliance needs to be remo-
ved from the electric grid. If the
appliance is not provided with a
non-separable flexible cable and plug,
14
, the
Publicidad
