Lamborghini Caloreclima KYRA D 30 UNIT Instrucciones Uso, Instalación Y Mantenimiento página 45

KYRA D
1. GENERAL INFORMATION
• Carefully read the warnings in this instruction booklet
• Once the boiler is installed, show its operation to the user and deliver this
instruction manual, which is an integral and essential part of the product and
must be carefully stored so that it can be consulted at any time.
• Installation and maintenance must be carried out by professionally qualified
personnel, according to current regulations and the manufacturer's instructions.
It is forbidden to handle any sealed regulation device.
• Incorrect installation or poor maintenance can cause damage or physical injury.
The manufacturer declines any responsibility for damage caused by errors in
installation and use or by failure to follow the manufacturer's instructions. Before
carrying out any cleaning or maintenance operation, disconnect the unit from he
power supply using the system switch and/or the special cut-off devices.
• Before carrying out any cleaning or maintenance operation, disconnect the
unit from the power supply using the system switch and/or the special cut-off
devices.
• In case of a fault and/or poor operation, deactivate the unit and do not try to repair
it or directly intervene. Contact professionally qualified personnel. Any repair/
replacement of the products must only be carried out by qualified personnel
using genuine parts. Failure to comply with the above can compromise the
safety of the unit. This unit must only be used for its intended purpose.
• This unit must only be used for its intended purpose
• Any other use is deemed improper and therefore hazardous.
• Do not leave the packaging elements within the reach of children as they are
dangerous.
• The equipment must not be used by children, nor by adults who have limited
physical, sensory or mental capabilities, or who do not have the necessary
experience and knowledge, unless they are instructed or supervised by another
person who is responsible for their use security.
• The unit can be used by children aged at least 8 years and by persons with
reduced physical, sensory or mental capabilities, or lacking experience or
the necessary knowledge, only if under supervision or they have received
instructions on its safe use and the related risks. Children must not play with the
unit. Cleaning and maintenance intended to be done by the user can be carried
out by children aged at least8 years only if under supervision.
• The unit and its accessories must be appropriately disposed of in compliance
with current regulations.
• The images given in this manual are a simplified representation of the product.
In this representation there may be slight and insignificant differences with
respect to the product supplied.
2. OPERATING INSTRUCTIONS
2.1 Introduction
Estimado cliente:
Thank you very much for choosing KYRA D, a LAMBORGHINI standing boiler
with advanced design, state-of-the-art technology, high reliability and constructive
quality. Please read this manual carefully, as it provides important information about
installation, use and maintenance.
The burner is pressurized.
KYRA D 30 UNIT - KYRA D 30 UNIT COND
-
Is a thermal generator for heating only, but can also be configured to be used as
a DHW producer by placing a cylinder (optional), a tank sensor (optional) and
a three-way valve (provided by the installer) ). In this case the control must be
configured as indicated in (pág.49).
- KYRA D 30 SI UNIT - KYRA D 30 SI UNIT COND
Inside it houses a stainless steel coil for DHW production.
- KYRA D 30 UNIT COND - KYRA D 30 SI UNIT COND
It is a condensing heat generator with high performance and low emissions. The
boiler body is made of high quality carbon steel and stainless steel.
2.2 Control panel
Panel key
1 = DHW temperature setting decrease button
2 = DHW temperature setting increase button
3 = Heating system temperature setting decrease button
4 = Heating system temperature setting increase button
5 = Display
6 = Summer / Winter mode selection button
7 = Economy / Comfort mode selection button
8 = Reset button
A73023800
9 =
Unit On / Off button
10 =
"Sliding Temperature" menu button
11 = Set DHW temperature reached
12 = DHW symbol
13 = DHW mode
14 = DHW outlet temperature / setting
15 = Eco (Economy) or Comfort mode
16 = External sensor temperature (with optional external probe)
17 = Appears on connecting the external Probe or the Remote Timer Control (optionals)
18 = Room temperature (with optional Remote Timer Control)
19 = Burner On
20 = Antifreeze operation
21 = Heating system pressure
22 =
Fault
23 =
Heating delivery temperature/setting
24 =
Heating symbol
25 = Heating mode
26 = Set heating delivery temperature reached
27 = Summer mode
Panel
fig.1 - Control panel
KYRA D 30 UNIT - KYRA D 30 UNIT COND:
-
NOTE: The series boiler is configured for its sole use in heating, so
the symbols referring to DHW will not appear on the display. These
symbols will appear when the boiler is configured for use with DHW.
Indication during operation
Heating
A heating demand (generated by the Room Thermostat or Remote Timer Control)
is indicated by flashing of the hot air above the radiator (details 24 and 25 - fig.1).
The heating graduation marks (detail 26 - fig.1) light up as the heating sensor
temperature reaches the set value.
DHW (Comfort)(Optional Configuration)
A DHW demand (generated by drawing domestic hot water) is indicated by flashing
of the hot water under the tap (details 12 and 13 - fig.1).
The DHW graduation marks (detail 11 - fig.1) light up as the DHW sensor
temperature reaches the set value.
fig.2
fig.3
EN
45