Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING - Risk of injury!
Components inside the unit may have sharp edges.
Wear protective gloves.
If the unit is not properly secured, it may fall.
All fasteners must be installed firmly and securely.
Changes to the electrical or mechanical structure are dangerous and can lead to malfunctions.
Do not make any changes to the electrical or mechanical structure.
The filter cover may vibrate (if the unit model is equipped with a cover)
Open the filter cover slowly.
When opening, hold the filter cover firmly until it stops swinging.
Close the filter cover slowly.
WARNING - Danger of electric shock!
Sharp-edged components inside the unit can cause damage to the connecting cable.
Do not bend or block the connection cable.
Improperly executed installations are dangerous.
The unit will be connected and used only according to the data on the technical data plate.
The unit will only be connected to a properly installed grounded alternating current outlet.
The protection system of the building's electrical power supply must be installed correctly.
Do not connect the unit to another switching source, for example a timed switch or remote
control system.
If the unit is mounted, free access to the mains cable plug must be ensured. If free access is
not possible, a phase separator for all poles will be installed in the permanent electrical
installation according to the conditions of the installation provisions.
When placing the unit, pay attention to the fact that the mains power cable is not stuck in one
place or damaged.
4.4 General remarks
When installing, keep these general notes in mind.
For installation, the construction regulations in force and those of the local electricity and
gas supplier must be respected.
4.5 Notes on the electrical connection
To be able to safely connect the unit to the power supply network, take these indications into
account.
WARNING - Danger of electric shock!
To be able to safely connect the unit to the electricity supply network, take these indications
into account.
It must be possible to disconnect the unit from the electricity supply network at any time. The
unit can only be connected to an outlet with a protective contact, installed according to
regulations.
EN
19
Publicidad
