Publicidad
Idiomas disponibles
Idiomas disponibles
5. INSTALLATION
ATTENTION!
This unit is designed to be installed and used on a wall
Keep this information in mind when mounting the unit.
5.1 Delivery package
After unpacking, check that the delivery is complete and that all parts are free of possible
See image
transport damage.
1. - cooker hood
2. - top pipe mask
3. - bottom pipe mask
4. - non-return valve
5. - top pipe mask bracket
6. - bottom pipe mask bracket
7. - hanging bracket
8. - reducer 150mm-120mm
5.2 Unit dimensions (mm)
See images
2a
2b
5.3 Safety distances
Observe the safety distances from the unit (calculated in mm).
5.4 Installation steps
1.Drill 3 holes (Φ8mm to accommodate your wall mounts) to install the bracket. Screw and fix
the bracket to the wall using 3 screws (ST4x30mm) and 3 wall plugs (not included). See the
image
4a
2. Place the hood and hang it using the two mounting lugs on the wall bracket.
See the image
4b
3. Secure the lower pipe mask bracket to the wall using 2 dowels and 2 ST4 x 30mm screws at
the marked locations. See the image
4. To install the air exhaust system, attach the exhaust tube (this accessory is not included) to
the air exhaust hole on the hood body. See the image
5. Slide the top of the piping mask to the bottom.
Attach to the upper section of the hood and mark the holes for the pipe mask bracket on
the wall.
6. Raise the upper portion of the tubing mask to the desired height. Mark the positions
for the mounting holes of the top bracket of the pipe mask on the wall and proceed to
pre-drill these points. Attach the top bracket of the pipe mask to the wall using 2 dowels
and 2 ST4 x 30mm screws at the pre-drilled points. See the image
7. Align the hook holes on the two sides of the top tube mask with the hooks on both sides
of the bracket, see the image
1
2c
2d
4c
4h
EN
See image
4d
4e
4f
21
3
4g
Publicidad
