Descargar Imprimir esta página

turbionaire elva 60 Manual De Usuario E Instrucciones De Instalación página 24

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 64
6.6 Connecting and disconnecting the lighting system
You can activate or deactivate the lighting system independently of the ventilation system.
to turn on.
Press
Press
k
6.8 Light temperature adjustment/light brightness adjustment
In standby mode, perform a 3-second long press on this
temperature adjustment function. Upon entering the light temperature adjustment state, the
LEDs on both the button
button or the button
temperature spans from 3200K for a warm color tone to 6500K for a cooler color tone, all within
a cycle (press the button to decrease, press the button
Once you've entered the light temperature adjustment mode, you can conveniently modify the
light's brightness by giving the button
100% - 75% - 50% - 75% - 100%. After confirming your preferred light temperature and
brightness settings, execute a long press on the button
temperature mode. The initial default light temperature is set to 3200K for a warm color tone.
6.9 Auto mode
In standby mode, perform a 1-second long press on the button
LED on the button
During monitoring, the fan remains inactive, while the light switch remains unrestricted.
Within this state, pressing the button
Upon completion of a 30-second detection period, a single beep will sound, signifying the
activation of Auto mode. The LED on the button will continue to exhibit a breathing flash
pattern. During automatic monitoring, real-time thermal sensing is employed. Following the
initial startup monitoring phase, the thermal probe will automatically adjust the motor's level
based on the detected heat. The current motor level is displayed on the switch (note: the lamp
operates concurrently with the level).
In situations where heat is not detected, a 3-minute delay precedes the shutdown, after which
the system transitions into automatic checking mode. While in automatic mode, performing a
long press on the button
operates normally. Should the Auto function be active and the fan manually switched on, the
Auto mode will disengage automatically. Upon turning off the fan, the system will seamlessly
re-enter Auto mode.
Note: Ensure that the thermal probe is positioned directly above the induction hob/gas hob.
6.9 Air cleaning function
In standby mode, perform a 1-second long press
function. This feature initiates the unit to operate at a low speed for 5 minutes, following
which it will automatically power down for 55 minutes. After this 55-minute period, the unit
will automatically switch on again for 5 minutes before repeating the 55-minute off cycle.
Once this function is enabled, it can only be deactivated by pressing the button
second. This deactivation does not impact other normal operations.
During the "5 minutes on" phase, the button
off" period starts, the Leaf
function be engaged and the fan manually switched on, the air cleaning function will halt
automatically. However, upon turning off the fan, the air cleaning function will automatically
resume.
again to turn off.
k
and button
to set the light temperature. The range of adjustable light
k
a
will exhibit a breathing flash pattern, indicating basic state monitoring.
a
a
restores the device to the standby state. The light function
LED will emit a steady green light. Should the air cleaning
EN
button to access the light
k
will flash simultaneously. At this point, you can use the
to increase).
a brief press. The brightness follows a sequence of
to exit the adjustable light
k
returns you to the standby state.
on the button to activate the air cleaning
LED will flash green. When the "55 minutes
24
a
to activate Auto mode. The
for 1

Publicidad

loading

Este manual también es adecuado para:

Elva 90