Floating Magnets - Balluff BTL5-P/I/K/L/M-M-P-S32/KA Serie Manual De Instrucciones

BTL5-P/I/K/L/M_-M_ _ _ _-P-S32/KA_ _
Micropulse Linear Transducer in Profile Housing
3 Installation (cont.)
Mounting brackets with isolation bushings
and M5 x 22 cylinder head screws, DIN 912,
max. tightening torque 2 Nm
Fig. 3-1: Dimensional drawing (BTL5...P-S32 transducer with floating magnet BTL5-P-3800-2)
Fig. 3-2: BTL5-P-3800-2 magnet
3.2

Floating magnets

The floating magnet (➥ ➥ ➥ ➥ ➥ Figs. 3-2 to
3-4) is attached to the moving
member of the machine using non-
magnetizable screws (brass, alumi-
num). To ensure the accuracy of the
transducer system, the moving
member must carry the magnet on a
track parallel to the transducer.
The following table provides figures
in [mm] for the spacing which must
be maintained between magnet and
transducer and for the permissible
center offset:
4
english
NL
Nominal stroke
55
45
E E
21
28
Fig. 3-3: BTL5-P-5500-2 magnet
Magnet type Distance
" D "
BTL5-P-3800-2 0.1 ... 4
BTL5-P-5500-2 5 ... 15
BTL5-P-4500-1 0.1 ... 2
Ensure that the distance E
between parts made of
magnetizable material and
the BTL5-P-5500-2 magnet is at
least 10 mm ( ➥ ➥ ➥ ➥ ➥ Fig. 3-3).
max. permissible
tightening torque 2 Nm
C
Ø 4.2
Fig. 3-4: BTL5-P-4500-1
electromagnet (24 V/100 mA)
Offset
BTL5-P-4500-1 magnet, special
" C "
features: Multiple magnets on the
same transducer can be turned on
± 2
and off individually (PLC control
± 15
signal).
± 2
The stroke range is offset 4 mm
towards the BTL connector/cable
( ➥ ➥ ➥ ➥ ➥ Fig. 3-4).