Element ELCHS192 Manual Del Usuario página 21

Appendix
Troubleshooting
Before calling a service technician, please check the following table for a possible cause of the problem and some
solutions.
Customer impo_ant notice: If the TV can not be operated, please unplug the power and restart.
Symptoms
TV will not turn on
No picture, no sound
No sound, picture OK
Possible Solutions
u
z
u
m
u
m
m
u
z
m
z
u
Poor sound, picture OK
Poor picture, sound OK
Unable to select a certain
channel
s
Poor co[our or no co[our
s
The remotecontro[ does
not operate o
m
s
Disorder display at power or
m
s
Remote control
programmin 9
Hake sure the power cord is plugged in, then press Power (Standby).
The remote control batteries may be dead, Replace the batteries.
Unplug the VGA wire and plug the power wire again.
Check if you have set the timer off.
Check the antenna!cable connections,
Press [Display] to see if you have selected the right signal source.
The sound may be muted. Press [VOL+ ] on the remote control.
The station may have broadcast difficulties. Try another channel.
Check the speakers cable connections.
Check if earphones are plugged into unit.
The station may have broadcast difficulties, Try another channel
Check the speakers cable connections.
Check the antenna connections.
The station may have broadcast difficulties, Try another channel.
Adjust the picture from the menu.
The channel may be skipped. Choose this channel by directly selecting
the buttons from the remote control,
The station may have broadcast difficulties, Try another channel,
Adjust Saturation in the Video settings menu.
There may be an obstruction between the remote control and the
remote control sensor.
The batteries may be installed with a wrong polarity.
The remote control batteries may be dead° Replace the batteries.
This may be caused because of a very short interval between POWER
OFF and ON.
Unplug the power and restart,
Cable and Satellite content providers control the remote codes,
and we apologize for any confusion during the remote programming.
Please try the following codes 10019, 0178, 10178, 0030, 10030,
083.5, 1083.5, or for Dish Network try 627, 6.59 or 50.5. For Fios
TV (Verizon), try the code 3264. These codes may not work on some
universal remotes. If there is another code listed for Element
Electronics in your universal remote control guide, please try that
code. Refer to the Remote Control Guide under your TV's model
number for more information.
You may also visit us at www.elementelectronics.com to address any product use and performance
questions you may have
19