Publicidad
Idiomas disponibles
Idiomas disponibles
Washer
is making
noise:
Washer
may need to be reinstalled.
(Check washer
installation
section.)
Washer
load may need to be re-balanced,
as the load
may be uneven.
Coins,
loose change,
buttons
or other heavy obiects
could make
noise (read
Operation
Guide
- Normal
Operating
Sounds.)
Squealing
Sounds'.
Due to overloaded
wash tub.
Vibration
Noises:
Due to not leveling washer
properly
on the floor
and uneven
distribution
of clothes
in the tub.
Problems
with
clothes:
Clothes
are too wrinkled:
this is due to improper
sorting,
overloading
and
washing
in too hot water
repeatedly.
Avoid
overloading
and resort your
load.
Do not mix heavy clothes
such as work clothes
with light clothes such as blous-
es, light shirts and delicate
items.
You may need to wash
in warm
or cold
water.
Have soap
residue', detergent
may not be dissolving
in water.
Check water
temperature
or you need to add detergent
as wash tub is being filled
with
water
before you load your clothes
to avoid
soap residue
on clothes.
Spots or stains on your clothes',
this is due to incorrect
use of fabric
softener.
You many need to read proper
instructions
on the container
and follow
proper
directions
for using the soflenen
Clothes
are grayed
or yellowed:
this is due to not pouring
enough
detergent
for large
loads,
you may have to add more detergent
to the load.
Clothes
are ripped
and have holes/excessive
wear and tear:
this is due to
sharp
objects
such as pins and belt buckles
left in pockets.
You will need to
remove
small
loose sharp
objects.
Fasten belts, zippers,
metal snaps etc.
Check
if you are using undiluted
bleach,
never add undiluted
bleach
to wash.
Trouble
Codes
E0
E!
E2
E3
E4
E5
E7
Reason
Top lid not closed during delay start sequence
Blockage of drain hose.
Top lid not closed during wash operation
The washer is out of balance
Water inlet valve closed
The water pressure is too low
The water level sensor fault - Call service
The communication
fault - Call service
11
Publicidad
