Skil 4339 Instrucciones De Funcionamiento Y Seguridad página 7

SM 2610998762 3/03 3/3/03
Attaching the Blad e
To prevent personal injury,
WARNING
!
always disconnect plug from
power source before assembling parts, making
adjustments, or changing blades.
STANDARD MODELS
1. Loosen blade screw in the blade holder and
insert blade to full depth with teeth facing in
direction of cut as shown in (Fig. 3).
2. Securely tighten blade screw on the side of
blade holder with a flat tip screwdriver.
TOOLLESS MODELS
1. Press collar ring down with index and
middle fingers.
2. Insert blade to full depth with teeth facing in
direction of cut as shown in (Fig. 4).
3. Release collar ring to secure the blade.
AUTO-SCROLL CUTTING MODELS
1. For Auto-Scrolling insert the blade to full
depth, with blade in the rear position of blade
holder as shown in (Fig. 5).
2. Securely tighten blade screw on the side of
blade holder with a flat tip screwdriver.
1. For Manual Scrolling and non scrolling
use, insert the blade to full depth, with blade
in the center position of blade holder directly
under the plunger as shown (Fig. 6).
2. Securely tighten blade screw on the side of
blade holder with a flat tip screwdriver.
CHIP DEFLECTOR
The chip deflector helps keep dust and chips
off the workpiece. The chip deflector simply
slides up and down for easy access to the
blade holder. For maximim visibility and blow
out, the chip deflector must be in the UP
position.
TRIGGER SWITCH WITH
"LOCK-ON" BUTTON
Your jigsaw can be turned "ON" or "OFF" by
squeezing or releasing the trigger. Your jigsaw
is also equipped with "Lock-ON" button
located just above the trigger that allows
continuous operation without holding the
trigger.
TO LOCK SWITCH ON: Squeeze trigger fully,
depress button and release trigger.
TO UNLOCK THE SWITCH: Squeeze trigger
and release it without depressing the "Lock-
ON" button.
4:34 PM Page 7
Assembly
Your jigsaw is equipped is with a dust port for
dust and chip extraction. To use this feature,
attach vacuum hose (optional accessory) to
the dust port, and connect opposite end the
hose to a shop vaccum cleaner.
BLADE
SCREW
COLLAR
RING
BLADE
SCREW
BLADE
SCREW
Operating Instructions
WARNING
!
depressed, the trigger cannot be released.
VARIABLE SPEED DIAL
Your Jigsaw saw is equipped with a variable
speed dial. The blade stroke rate may be
adjusted during cutting operation by
presetting the dial on or between any one of
the six numbers.
Setting SPM rating (strokes per minute)
1-2 Low stroke
3-4 Medium stroke
5-6 High stroke
-7-
DUST EXTRACTION
FIG. 3
BLADE
HOLDER
FIG. 4
BLADE
HOLDER
FIG. 5
BLADE
HOLDER
FIG. 6
BLADE
HOLDER
If the "Lock-ON" button is
con ti n u ou sly bein g