GE AVM4160 Instrucciones De Instalación página 19

Installation Instructions
ASSEMBLE AND INSTALL ADAPTOR
_l_ Place the microwave oven in its upright position, with
the top of the unit facing up and the front of the unit
facing toward you,
Remove the screw on the back side of the blower
plate and raise the blower plate off of the microwave,
_ Slide the damper from left to right into the tabs on the
blower plate, The yellow tape on the damper should
be facing away from you,
[_ Remove the yellow tape from the damper,
Make sure
that the damper pivots easily before mounting
microwave oven.
You will need to make adjustments to assure proper
alignment with your house exhaust duct after the
microwave oven is installed,
Position the blower plate with damper back on the
microwave and secure it with the screws that were
removed,
MOUNT THE MICROWAVE OVEN
, CAUTION:
_o avoid the risk of personal
injury (back injury or other injuries due to excessive
weight of the microwave) or property damage, you
will need two people to install this microwave.
IMPORTANT: Do not grip or use handle during
installation,
AWARNING: Risk ofElectric Shock. Can
cause injury or death: If installing unit with metal
countertops, cover the edge of the power supply
cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws,
NOTE: When mounting the microwave, thread power
cord through hole in bottom of top cabinet, Keep it
tight throughout Steps 1-3, Do not pinch cord or lift
microwave oven by pulling cord,
_l_ Lift microwave, tilt it forward, and hook slots at
back bottom edge onto four lower tabs of mounting
plate,
Power Cord
_ Rotate front of microwave oven up against cabinet
bottom,
19