•
Connect the USB cable (C) to the USB charging socket (A) with a power
source such as a USB Charger, the USB-socket of your computer or a power
bank to charge the battery.
•
Before the first usage, the battery should be fully charged. Once it is fully
charged, the night light is ready to use.
Usage
•
Switch the night light on/off with by pressing the power button (A). You can
only access the warm-white light mode by using the power button(A).
•
To access the automatic colour change mode, use the touch sensor of the
night light by touching the silicone body while it is turned on. This way you
can switch between the 3 modes (Warm-white light, Automatic colour
change, Off).
•
Please note that the night light must be activated with the help of the power
button (A) on the bottom before the first usage of the touch sensor.
•
The same applies in case you turned off the night light with the help of the
power button (A). You can only turn the night light back on with the touch
sensor if you have also turned it off with it.
NOTICE
Please note that the colours change smoothly from one to another.
Depending on the lighting in the room the light might not be noticeable for the
first 3 seconds.
Energy saving function
•
The night light is equipped with an energy-saving function, which will turn
off the night light automatically after one hour of operation.
•
To reactive it, the power button (C) on the bottom side needs to be pressed.
CLEANING AND MAINTENANCE
m WARNING
Risk of electric shock!
•
During cleaning do not immerse the electrical parts of the product in water
or other liquids.
•
Never use corrosive detergents, wire brushes, abrasive scourers, metal or
sharp utensils to clean the product.
•
The light unit can be easily be removed which allows you to clean the silicon
body under running water. Alternatively, you can clean the night light with a
dry or slightly damp cloth.
•
Any other servicing than mentioned in this manual should be performed by a
professional repair centre.
9