Allen + Roth WSWS-CS1C Manual Del Usuario página 4

SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
• Do not allow children to climb or play in or around this product.
• To avoid damage, assemble the product on a sturdy, level and protective surface.
• Two or more persons must work together to install the unit onto the wall.
• Make sure all bolts/screws are tightly fastened before the unit is used.
• Check bolts/screws periodically and tighten them if necessary.
•
Unit must be permanently fastened to the wall with provided hardware; this storage
unit is not designed or intended for freestanding use.
WARNING
UNIT IS INTENDED FOR USE ONLY WITH MAXIMUM WEIGHTS INDICATED.
OVERLOADING STORAGE UNIT WITH PRODUCTS HEAVIER THAN MAXIMUM
WEIGHT MAY RESULT IN INJURY. DISTRIBUTE ANY WEIGHT IN UNITS EVENLY.
• Shelf maximum load: 30 lbs.
• Pole maximum load: 40 lbs.
• Pole maximum length: 60 in.
CAUTION
• Use this unit for its intended purpose only.
• Do not use shelves as step ladder.
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list and hardware contents list. If any part is missing or damaged, do not attempt to
assemble the product.
Estimated Assembly Time: 120 minutes
Tools Required for Assembly (not included): Phillips Screwdriver, Power Drill, 3/16 in. Drill Bit, 3/8 in.
Drill Bit, 1/2 in. Socket Wrench, Level, Stud Finder, Marking Pencil, Tape Measure, Step Ladder, and
Hammer
6
ASSEMBLY INSTRUCTIONS
Base Assembly
1. Press the release lever on slides (U) and
remove the slide runner.
2. Attach slides (U) to base panel left (H) and base panel
right (I), securing with M6 x 10 mm screws (JJ). Then,
insert medium cam bolts (EE) into base panel left (H),
base panel right (I) and base panel top (J).
Hardware Used
EE
Medium Cam Bolt
JJ M6 x 10 mm Screw
3. Attach base panel back (K) and bast panel top (J) to
assembly using large wood dowels (HH) and large cam
lock (DD).
Note: Make sure previously inserted medium
cam bolts (EE) are completely seated.
Hardware Used
DD
Large Cam Lock
HH Large Wood Dowel
1
Release Lever
UP
U
2
EE
JJ
U
x 12 H
x 4
I
EE
TT
3
HH
K
J Back Side
x 2
x 2
DD
7
J
JJ
U