Westward 46V232 Manual De Instrucciones página 12

Westward Operating Instructions and Parts Manual
31. Assemble the two pivot bars to the front tongue section using four M8X20 hex bolts (D), Ø8 lock washer (K), Ø8
Flat Washer (U) and M8 hex nuts (H). Don't tighten yet. See Figure 14.
32. Assemble the pivot bars to the rear tongue section using a M12X120 hex bolt (A) and Ø12 Flat Washer (L) and
M12 hex lock nut (I). Tighten the lock nut ,leaving it just loose enough to allow the front tongue to pivot. Now
tighten the four hex bolts, lock washers and hex nuts assembled to the front tongue in Step 31.See Figure 14.
33. Assemble the hitch bracket to the front tongue section using two M8X20 hex bolts (D), Ø8 lock washer (K), Ø8
flat washer (U) and M8 hex nuts (H), and tighten. See Figure 15.
34. Assemble the hitch pin through the hitch bracket and the tongue and secure with the hair cotter pin shown in
Figure 15.
35. Place the tailgate down into the tailgate guides with the top and bottom lips of the tailgate facing to the rear.
36. If you have not yet greased the wheels, fill the wheel hubs with automotive bearing type grease.
2000LB STEEL DUMP CART
FIGURE 14
FIGURE 15
12
46V232