Publicidad
Idiomas disponibles
Idiomas disponibles
Westward Operating Instructions and Parts Manual
4.
Position the two pieces cart body upright on a smooth level surface such as a garage floor or a paved driveway.
See figure 2.
5.
Assemble the cart body together by using nine Round Head Bolt M6x16 (E), Flat Washer Ø6 (T), Lock Washer
Ø6 (J) and Hex Nut M6 (G) as shown in Figure 2.
Do not tighten at this stage.
6.
Position the tailgate reinforcement bracket on outside of cart as show in figure 3. Assemble the bottom of the cart
body using six Round Head Bolt M8x16 (F), Flat Washer Ø8 (U), Lock Washer Ø8 (K) and Hex Nut M8 (H). Do
Not tighten. See Figure 3.
7.
Position the tailgate guides with the holes to the rear as shown in figure 3. Assemble the guides to the inside of
the cart using six Round Head Bolt M6x16 (E), Flat Washer Ø6 (T) , Lock Washer Ø6 (J) and Hex Nut M6 (G).
Do Not tighten.
8.
Assemble two Round Head Bolt M6x16 (E), Flat Washer Ø6 (T), Lock Washer Ø6 (J) and Hex Nut M6 (G) to the
top rear corners of the cart. Do Not tighten. See Figure 3.
9.
Tighten the six bolts assembled in step 6 and the two bolts in step 8.Tighten the nine bolts assembled in step 5,
keeping the bottom of the cart body halves even.
2000LB STEEL DUMP CART
Tailgate Guide
FIGURE 3
6
46V232
FIGURE 2
Publicidad
