Publicidad
Idiomas disponibles
Idiomas disponibles
Westward Operating Instructions and Parts Manual
10. Lower the cart to rest upside down on the top flanges. See Figure 4.
11. Assemble the wheel support at the rear of the cart using twelve M8X16 round head bolts (F), Flat Washer Ø8 (U),
Lock Washer Ø8 (K) and M8 hex nuts (H) as shown in Figure 4. Bolt heads go on inside of cart. Tighten all
wheel parts now.
12. Connecting the 2 wheel supports by eight M8X20 Hex Bolts (D), Flat Washer Ø8 (U), Lock Washer Ø8 (K) and
M8 Nuts (H).
13. Assemble the axle through the wheel support as shown in Figure 5.
14. Apply grease to the ends of the axle now or use a grease gun after the wheels are assembled.
15. Assemble a Ø20 flat washer (R) , a wheel ( valve stem out) ,another Ø20 flat washer (R) and a cotter pin (O) to
each end of the axle as shown in Figure 5.
16. Assemble a hub cap over the Ø20 flat washer (R) on each end of the axle as shown in Figure 5.
2000LB STEEL DUMP CART
FIGURE 4
7
46V232
FIGURE 5
Publicidad
