Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Preparing
the appliance
C3 Remove the side brackets and fixing plates which
attach the furniture fronts.
To do this, loosen the fastening
screws and remove
the stop parts.
[_
Store the stop parts in suitable receptacles,
otherwise
they may get lost.
D=24-25
W'
(610-647)
4.
Preparing
the installation
cavity
[_2
anti tip brackets are required for each appliance
or appliance
combination
(Side by Side).
[3
Specify the attachment
points of the
anti tip brackets.
Specify the detailed dimensions
according
to the
section on "Installation
dimensions"
starting on
page 8.
C3
If the installation
cavity is deeper than the appliance,
place a solid wooden
beam behind the
anti tip brackets and attach securely to the base or
the walt.
The length of the wooden
beam is equal to the
width of the installation
cavity!
If possible,
always screw the wooden
beam to
existing studs on the rear panel of the cavity.
In some installations
the sub flooring or finished floor
may necessitate
angling the wood screws used to
fasten the anti tip brackets
to the back walt.
Important
information
for secure attachment
of the
anti tip brackets:
The supplied
set contains fastening
screws for
various applications.
Select the fastening
screws
according
to the local conditions.
If the supplied fastening
screws do not permit
secure attachment
of the anti tip brackets and
therefore the appliance,
another method must
be used to attach the anti tip brackets
securely.
Assure that there are no electrical wires or plumbing
in the area which the screws could penetrate
risk of
injury and damage!
13
Publicidad
