Ratio R-AT36 Manual De Instrucciones página 36

OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The power tool is intended for driving in and
loosening screws.
BEFORE OPERATING THIS TOOL
A) CHARGING THE BATTERY
The battery charger supplied is only for the Li-
ion battery installed in the machine. Do not use
another battery charger.
The Li-ion battery is protected against deep
discharging. When the battery is empty, the
machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
When the battery pack is charged for the first
time or after prolonged storage, the battery pack
will accept a 100% charge after several charge
and discharge cycles.
B) CHARGING (SEE FIG. A)
Plug the charger plug into a suitable power
outlet. Next, connect the charger to the charging
socket on the screwdriver.
Let the battery charge for 3-5 hours. The battery
will be fully charged. Then unplug the charger.
Disconnect the charger from the screwdriver. The
screwdriver is ready to be used.
Important:
When charging, the charger and screwdriver may
become warm to the touch; this is normal and
does not indicate a problem.
C) CHARGING (SEE FIG. A)
A
36
OPERATION
1. FITTING AND REMOVING BITS (SEE FIG. B)
Insert the bit into the chuck and push the bit into
the chuck as far as possible. To remove the bit,
simply pull it out of the chuck.
B
2. FORWARD / REVERSE SWITCH(SEE FIG. C)
This allows direction to be changed for driving
and removing screws/sockets. Push the bottom
of the rocker switch for driving forward (d) and
push the top for removing screws/reverse (c).
C
c
d
WARNING:
Never change the direction of rotation when
the chuck is rotating. Wait until it has stopped.
3. FULLY AUTOMATIC SPINDLE LOCKING
(AUTO-LOCK) (SEE FIG. D)
The screwdriver chuck is locked when the on/off
switch is not pressed.
This allows the driver to be used manually when
needed.
Important:
When using as a manual tool, do not press the
on/off switch. Otherwise the screwdriver will be
damaged.