Wesco WS2302 Manual Original página 10

SYMBOLS
To reduce the risk of injury, user must read
instruction manual
Warning
Double insulation (only for charger)
Wear ear protection
Wear eye protection
Wear dust mask
Waste electrical products must not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authorities or retailer for
recycling advice.
Indoor use only(only for charger)
Batteries may enter water cycle if disposed
improperly, which can be hazardous for
ecosystem. Do not dispose of waste batteries as
unsorted municipal waste
Do not burn
Read the operator's manual.
Positive terminal
10
Negative terminal
T 2A
Fuse
Li-Ion battery This product has been marked
with a symbol relating to 'separate
collection' for all battery packs and battery
pack. It will then be recycled or dismantled
Li-I on
in order to reduce the impact on the
environment. Battery packs can be
hazardous for the environment and
for human health since they contain
hazardous substances.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book
carefully.
INTENDED USE:
The machine is intended for dry sanding of wood, plastic, filler and
coated surfaces.
BEFORE OPERATION
1. CHARGING THE BATTERY PACK
a) Do not use any charger other than that specifically provided for
use with the equipment.
b) If the battery pack is very hot you must remove your battery
pack from the charger and allow time for the battery to cool
down before recharging.
c) The battery in your new tool is not charged when it leaves the
plant. Therefore it must be full charged before using the first
time.
d) Please charge the battery to reach full or no less than half
charge before storage. If the tool will not be used for long periods
of time, charge the battery every 3-6 months.
CHARGING PROCEDURE (SEE FIG. A)
1) Plug the charger into an appropriate outlet. The light will be
green.
2) Slide the battery pack into the charger, the light will turn to red to
indicate the charging process has started.
3) When charging is completed, the light will turn to green. The
pack is now fully charged, unplug the charger and remove the
battery pack.
CHARGING INDICATOR
This charger is designed to detect some problems that can arise
with battery packs. Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack to determine if the
charger is OK. If the new battery charges correctly, then the original
pack is defective and should be returned to a service center or
recycling service center. If the new battery pack displays the same
problem as the original Battery Pack, have the charger tested at an
authorized service center.
EN