Wesco WS2302 Manual Original página 12

or with circular motion and moderate pressure. For the second and
third applications of polish, repeat as above. The pad cover will not
adsorb as much when reloading.
Do not allow the polishing pad to dry out on the surface, otherwise
the surface can become damaged. Do not subject the surface to
direct sunlight.
Clean the polishing pad regularly to keep good polishing results.
Wash out polishing bonnet with a mild detergent and warm water.
WORKING HINTS FOR YOUR SANDER
If your power tool becomes too hot, especially when used at low
speed, set the speed to maximum and run with no load for 2-3
minutes to cool the motor. Avoid prolonged usage at very low
speed. Always use a sanding paper suited to the material you wish
to sand. Always ensure the work-piece is firmly held or clamped
to prevent movement. Support large panels close to the sanding
area. Any movement of the material may affect the quality of the
sanding finish. Start your sander before sanding and turn off only
after stopping sanding. For best results, sand wood in the direction
of the grain. Do not start sanding without the sanding paper fitted.
Empty the dust bag every 5 minutes or sooner to ensure efficient
dust collection.
MAINTENANCE
Remove the battery pack from the tool before carrying out any
adjustment, servicing or maintenance.
Your tool requires no additional lubrication or maintenance.
There are no user serviceable parts in your power tool. Never use
water or chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working controls free of
dust. Occasionally you may see sparks through the ventilation slots.
This is normal and will not damage your power tool.
For Battery tools
The ambient temperature range for the use and storage of tool and
battery is 0 C-45 C.
o o
The recommended ambient temperature range for the charging
system during charging is 0 C-40
o
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling
advice.
12
C.
o
PLUG REPLACEMENT (ONLY FOR
REWIRABLE PLUG OF UK & IRELAND)
If you need to replace the fitted plug then follow the instructions
below.
IMPORTANT
The wires in the mains lead are colored in accordance with the
following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the mains lead of this appliance
may not correspond with the colored markings identifying the
terminals in your plug, proceed as follows. The wire which is
colored blue must be connected to the terminal which is marked
with N. The wire which is colored brown must be connected to
the terminal which is marked with L.
WARNING!
Never connect live or neutral wires to the earth terminal of the
plug. Only fit an approved BS1363/A plug and the correct rated
rated current fuse which is used in the plug.
Note: If a moulded plug is fitted and has to be removed take
great care in disposing of the plug and severed cable, it must be
destroyed to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
clamped
TROUBLESHOOTING
1. If your sander will not operate, check the battery pack.
2. If the sander does not abrade surface, checking the sanding
paper. If the sanding paper has been worn, replace the new
paper and try again. The paper must be kept in a dry place, if
it is allowed to become damp, the abrasive particles will lose
their adhesion to the backing paper and will not abrade.
3. If the sander dose not move smoothly, The sanding paper
may be loose, damaged or wrinkled. Replace and try again.
4. If a fault can not be rectified return the sander to an
authorized dealer for repair.
Fuse
Brown L(live)
Cable grip
EN