Publicidad
Idiomas disponibles
Idiomas disponibles
Start up
Considerations for battery use
• The battery is shipped in a discharged state from the factory. It
needs to be charged for approximately 55 minutes before it can
be used.
• Charging should take place within a normal temperature range
of 0 ºC to 45 ºC; if the temperature is outside this range, charging
will automatically pause until the correct temperature is reached.
The standard operating temperature during discharge is 0 ºC to
75 ºC. If the temperature exceeds 75 ºC, the electronic control
Battery charging
1. Plug the charger into a 127 V~ power outlet (The charge
indicator's green light will illuminate).
2. Slide the battery into the charger. The green light will go off,
and the red light should illuminate, indicating the start of
charging. Additionally, the battery level indicator will flash in a
sequence of red-orange-green.
3. Once the battery is fully charged, the green light will illuminate
again, and the red light will turn off.
4. Unplug the charger once the charging is complete.
BATTERY FAULTS
If the green LED stays on, and the battery's red LED flashes due
to overheating, wait until the battery temperature is within the
appropriate range before charging.
Installation of the saw blade
WARNING
WARNING
Make sure the blade
holder is free of material
debris (such as splinters of wood or metal).
• Turn the clamping lever as far to the left as
possible and hold it in this position. • Insert
the saw blade in the chuck. Check
that the saw blade is securely fixed and that
the teeth are pointing in the cutting direction.
• Let go of the clamping lever. Check
whether the back of the saw blade is
positioned in the center of the guide roller.
WARNING
Make sure to use the right sawblade for the corresponding
material. Included with the machine is a coarse sawblade for wood.
• To remove the saw blade, turn the clamping lever as far to the left as possible and
hold it in this position. Remove the saw blade from the chuck. Let go of the
clamping lever.
Plastic base protector
The tool comes with a protective cover for the base
plate to safeguard delicate surfaces. To install it, attach
the protector to the front of the base plate and then
press it toward the back until you hear a clicking
sound.
will cut off power to the tool until the temperature
returns to the optimal range. If the temperature falls
below the normal voltage during operation, the tool will
cease functioning.
• Allow a 15-minute break for the charger between each
charging cycle. In warm environments or after extended
use, the battery may become too hot for recharging.
Allow the battery to cool before attempting to recharge it.
2
We recommend using
a TRUPER Brand "T"
type shank blade.
1
7
ENGLISH
Publicidad
